Air Emission Monitoring
Hot-Wet CEMS
An extractive emission monitoring system that keeps the sample hot from the stack to the analyzer.
View product
Services
Installation & Commissioning
Installation and testing of monitoring systems under real site conditions, until the system is handed over with documentation that can be checked again later.
01
When this service is needed
- New projects, or units newly required to monitor emissions continuously.
- Replacing an old CEMS. Replacing a CEMS also requires re-integration into SISPEK (Permen LHK No. 13 of 2021, Article 7).
- Relocating a measurement point or changing the sample route.
- A system that was purchased but never properly commissioned.
02
Service scope
- Site survey: measurement point, platform access, utilities, cable and sample routes.
- Mechanical and electrical installation: probes, sample lines, shelter or cabinet, and panels.
- Data integration with the data logger, DIS, or DCS.
- Commissioning: functional checks and testing while the unit operates.
- Handover documentation and operator training.
03
How we work
We do not install from drawings alone. Every job starts with a survey, because the condition of the measurement point and sample route in the field determines whether the data will be trustworthy.
The system is handed over after testing under operating conditions, and every finding is recorded in the handover documentation.
- Site surveyMeasurement point, access, utilities, cable and sample routes
- InstallationMechanical, electrical, and sample lines
- Initial checksFunctions, signals, and data communication
- Operating-condition testSystem tested while the unit operates
- HandoverDocumentation and operator training
Products we typically support
Air Emission Monitoring
Cold-Dry CEMS
An extractive emission monitoring system that dries the sample before analysis.
View product
Air Emission Monitoring
Dust & Flow Monitor
In-situ instruments that measure dust concentration and flue gas flow directly inside the stack.
View product
Contact
Tell us about monitoring at your site.
Choose the route that fits best. Our team reviews your needs, site conditions, and timeline before preparing a recommendation.
01
Technical consultation
Discuss parameters, measurement points, and site conditions before choosing a system.
- Phone
- (021) 645 6305
- info@ptpid.com